![]() |
| | |||||||
| Registreer | Adverteerders | FAQ | Ledenlijst | Interessegroepen | Zoeken | Berichten van vandaag | Markeer forums als gelezen |
![]() |
| | Discussietools | Weergave |
| | #1 (permalink) |
| Lid sinds: 18 september 2004 Locatie: Moordrecht Leeftijd: 34
Berichten: 3.988
| http://video.google.nl/videoplay?doc...659961&q=plane Quote: Date: 27 AUG 1992 Time: 10:20 Type: de Havilland Canada DHC-4T Caribou Operator: NewCal Aviation Registration: N400NC Msn / C/n: 240 Year built: 1965 Crew: 3 fatalities / 3 on board Passengers: 0 fatalities / 0 on board Total: 3 fatalities / 3 on board Airplane damage: Written off Location: Gimli, MB (Canada) Phase: Initial climb (ICL) Nature: Test Departure airport: Gimli Airport, MB (YGM) Destination airport: Gimli Airport, MB (YGM) Narrative: The aircraft took off for a test flight for a turbine-engine conversion programme. It climbed steeply, rolled to the right and crashed in a nose-down, rightwing-low attitude. This accident ironically occurred in Manitoba, at Gimli – the site of the Air Canada 767 fuel-exhaustion incident. The aircraft involved was an experimental, modified version of the Caribou which had undergone conversion to turbine power, and was being tested to check fuel and hydraulic systems on the date of the crash, 27 August 1992. Although the aircraft apparently rotates and climbs normally, photographic evidence indicates that control-surface movement was minimal, suggesting that the gust-locks were engaged. While there was elevator movement upon rotation, the elevators returned to the neutral position and remained there. This is in line with the operation of the gust-lock – if the control surfaces are not in the neutral position when the lock is engaged, movement of the surfaces through neutral will engage it. In addition to preventing control-surface movement, the gust-lock lever is supposed to inhibit the power levers to prevent the pilot from applying take-off power. It was found that the aircraft’s take-off distance was 20% longer than expected. Wreckage analysis determined that the rudder lock was fully engaged and the aileron lock had only been disengaged at the moment of impact, supporting the conclusion that the gust-lock system had not been fully disengaged ahead of the flight, and that at least some of the locks had engaged after take-off. Moral of the story: Check you have complete, free movement of all your control surfaces before you go anywhere. The lock that was left in was a cable lock which is attached to a cable to retain tension on a cable while one or both ends are disconnected. In this case several people would have been at fault. The mechanic whose responsibility it was to remove the lock, the mechanic responsible for the flight control rig check required due to the disconnecting of that cable, and then finally the flight crew who should have caught the reduced control column movement. It's sad to see that these people died because of something that was missed by at least three sets of eyes. It is also a reminder of how critical it is to have competent, experienced mechanics with high integrity.
__________________ Al mijn gratis tekeningen vanaf nu te downloaden op http://www.rcplans.nl Laatst gewijzigd door prop-er; 6 september 2008 om 22:59 |
| | |
| | #2 (permalink) |
| Lid sinds: 10 oktober 2002 Locatie: Huizen, BosModelAir basis Leeftijd: 36
Berichten: 17.371
|
Tja, niet de eerste kist die de grond in gaat doordat de piloot vergeet de "gust-lock" te verwijderen
__________________ Zie al onze modelvliegtuigen op: BosModelAir |
| | |
| | #3 (permalink) | |
| Lid sinds: 17 december 2004 Locatie: rotterdam
Berichten: 2.205
| Citaat:
gr, niels
__________________ Echte mannen eten geen honing, die kauwen bijen! | |
| | |
| | #4 (permalink) |
| Lid sinds: 10 oktober 2002 Locatie: Huizen, BosModelAir basis Leeftijd: 36
Berichten: 17.371
|
een "gust-lock" is een apparaatje wat de roeren blokeert tijdens bijv. parken/overnachting. Een Cessna 172 heeft een staafje wat je door de stuurkolom drukt en zo de roeren blokeert. Er is zijn eens een piloten vertrokken met de gust-lock er nog op met vaak als resultaat bovenstaan filmpje, je kunt namenlijk je roeren niet bedienen en zo`n gust-lock verwijderen als je eenmaal snelheid heb is onmogelijk met de druk die dan al op de roeren staat. Als je dan geen baan meer over hebt dan heb je een probleem, of zoals bovenstaan voorbeeld dan kom je los zonder dat je kan sturen en dan is het over en uit.
__________________ Zie al onze modelvliegtuigen op: BosModelAir |
| | |
| | #5 (permalink) |
| Lid sinds: 7 oktober 2005 Locatie: Wooden-City (Houten) Leeftijd: 49
Berichten: 335
|
Gust lock ? Volgens mij is dat een apparaat om de beweegbare roeren tijdens het parkeren te fixeren. Dat de wind geen vat heeft op de roeren als ze niet gebruikt worden en schade te verkomen. ![]() A simple device to keep the ailerons from flapping in the wind while parked Greetz Mario Many thanks to GOOGLE
__________________ * Je bent niet te oud om te spelen, je word pas oud als je niet meer speelt * |
| | |
| | #6 (permalink) |
| Lid sinds: 2 oktober 2003 Locatie: Den Haag Leeftijd: 74
Berichten: 678
|
Dan is hier kennelijk niet de juiste procedure gevolgd. De platform crew behoort alle locks te verwijderen en die gaan in een kistje aan boord. Daar behoort de purser of de vlieger alle locks te controleren en te tellen, anders mag hij niet weg. Groetjes Hans.
__________________ een dag zonder hobby is een dag niet geleefd! Een half ons geluk doet meer dan een kilo wijsheid! |
| | |
| | #7 (permalink) | |
| Lid sinds: 10 oktober 2002 Locatie: Huizen, BosModelAir basis Leeftijd: 36
Berichten: 17.371
| Citaat:
De crash in eerst genoemde post was met een gemodificeerde kist en die zullen in de spanning wel wat vergeten zijn.\ De crashes met cessna`s etc. is een leuke "pilots error".
__________________ Zie al onze modelvliegtuigen op: BosModelAir | |
| | |
| ||||||
![]() |
| Discussietools | |
| Weergave | |
| |