Modelbouwforum.nl


Ga terug   Modelbouwforum.nl > Algemeen > FullScale-Forum

Reageren
 
Discussietools Weergave
Oud 8 oktober 2007, 23:38   #1 (permalink)
 
prop-er's schermafbeelding
 
Lid sinds: 18 september 2004
Locatie: Moordrecht
Leeftijd: 34
Berichten: 3.916
Standaard Chinese Boeing 737 benut de hele baan...

__________________
Al mijn gratis tekeningen vanaf nu te downloaden op http://www.rcplans.nl

Laatst gewijzigd door prop-er; 16 februari 2008 om 22:00
prop-er is offline   Met citaat reageren
Oud 8 oktober 2007, 23:43   #2 (permalink)
 
Bertus's schermafbeelding
 
Lid sinds: 23 september 2002
Leeftijd: 41
Berichten: 7.964
Standaard

Goeie dag zeg.
Waar was dat voor nodig?
__________________
Groeten Bertus
http://www.youtube.com/watch?v=AOA_pAigJ6c
Bertus is nu online   Met citaat reageren
Oud 9 oktober 2007, 01:16   #3 (permalink)
 
Airbus's schermafbeelding
 
Lid sinds: 30 oktober 2004
Berichten: 2.112
Standaard

te zwaar beladen?
Airbus is offline   Met citaat reageren
Oud 9 oktober 2007, 01:58   #4 (permalink)
 
Lid sinds: 24 augustus 2007
Locatie: hoogezand
Berichten: 207
Standaard

gaat ook echt maar net goed he !
__________________
leuke tekening ,veel ideeen ,maar alleen nog maar een spanten romp en klein spul ,moet nog wat worden
erik16v is offline   Met citaat reageren
Oud 9 oktober 2007, 02:01   #5 (permalink)
Benji
Guest
 
Berichten: n/a
Standaard

Wat is dat rookwolkje dan wat je ziet verschijnen op het moment dat hij het einde bereikt?
Of is dat gewoon opstuivend zand?

Je zou toch doodsangsten uitstaan als je daar inzit? :S
  Met citaat reageren
Oud 9 oktober 2007, 09:06   #6 (permalink)
 
skyhigh's schermafbeelding
 
Lid sinds: 24 april 2007
Locatie: Utrecht .
Leeftijd: 16
Berichten: 1.362
Weblogartikelen: 1
Standaard

IEKS ,dat was vast niet de bedoeling



Skyhigh
skyhigh is offline   Met citaat reageren
Oud 9 oktober 2007, 10:27   #7 (permalink)
 
prop-er's schermafbeelding
 
Lid sinds: 18 september 2004
Locatie: Moordrecht
Leeftijd: 34
Berichten: 3.916
Standaard

http://www.luchtvaartnieuws.nl/news/?id=22486

Bijna 'overrun' toestel China Airlines tijdens start (video)

08-10-2007

SAGA - Een vliegtuig van China Airlines is vrijdag (5 oktober) ternauwernood ontsnapt aan een crash. Tijdens de start vanaf het Japanse Saga Airport had het toestel veel moeite om ‘los’ te komen. De Boeing 737-800 koos vlak voor het eind van de startbaan op het nippertje het luchtruim, zo blijkt uit videobeelden van de Japanse televisie.

Op de videobeelden lijkt het alsof het hoofdlandingsgestel iets op de grond raakt vlak voordat het toestel ‘airborne’ is. Gesuggereerd wordt dat het een lamp betrof, die na een inspectie kapot bleek te zijn.

Het vliegtuig keerde na een half uur terug op hetzelfde vliegveld, omdat de vliegers problemen ondervonden met de snelheidsmeters.

Het toestel is dezelfde Boeing 737 waarbij eind vorige maand een zeventig centimeter lange scheur in de romp werd gevonden. Het toestel was net gerepareerd en vertrok daarom zonder passagiers terug naar Taipei.

http://www.luchtvaartnieuws.nl/news/?id=22224


http://www.japannewsreview.com/socie...06page_id=2291
China Airlines jet hits ramp at end of Saga Airport runway
A China Airlines jet taking off from Saga Airport went 60 meters beyond its runway before it finally became airborne. The airplane was 30 minutes later forced to return to the same airport after the pilots experienced trouble with its speedometers, the Asahi Shimbun reports.

The jet, a Boeing 737-800, had just finished repairs after a 28 inch crack had been found in the plane’s fuselage last month, was not carrying any passengers and there were no injuries or damage reported.

The plane was unable to take off after having passed through the entire runway, and went 60 meters into the so-called “overrun zone.” The jet also hit one of the 5 ramps placed at the end of the overrun zone, probably with one of its wheels, airport officials commented. An AP report also suggested one of the lamps at the end of the runway had been discovered broken, although it was unclear whether it was linked to Friday’s incident.

According to an official from the Transport Ministry official there had been a discrepancy between the output of the pilot and co-pilot’s speedometers, which also made the pilot’s decide to return to Saga airport.

A China Airlines jet of the same model exploded into a fireball at Okinawa’s Naha Airport on Aug. 20, after all passangers and crew members had been evacuated to safety.



http://www.flightglobal.com/articles...y-updated.html
A China Airlines (CAL) Boeing 737-800 nearly ran off the end of a runway on takeoff in southern Japan on 5 October.

The aircraft only got airborne at the end of the runway and the main landing gear appears to have hit something on the ground as it took off, according to television footage taken at the scene.

Some news reports say a broken runway light was later found at the end of the runway.

A CAL spokesman in Taipei says the incident happened at around 14:00 on 5 October at Japan’s Saga airport and it was the same aircraft that had been parked at Saga airport since 20 September undergoing repairs.

The aircraft, registered as B-16805, needed to be repaired because it had a 77cm crack in the rear fuselage.

When asked why the aircraft appeared to have been travelling down the runway slowly and only got airborne at the end, CAL’s spokesman says there was a problem with the aircraft’s speed indicator. There was a substantial difference between what the captain’s was showing and what the co-pilot’s was showing, he adds.

He also says that after takeoff the captain returned the 737 to Saga because he was concerned about the speed indicator and the fact that weather near Taiwan would be bad because of a typhoon.

There was no damage to the aircraft as a result of the takeoff and no passengers were on board because it was on a ferry flight back to Taiwan, he adds.

It is unclear whether the Japanese authorities will be investigating this latest incident, says the spokesman. He adds that when the aircraft eventually returns to Taiwan it will be grounded for a few days for inspections before entering commercial service.

A spokeswoman for Taiwan’s Aviation Safety Council (ASC) says that at this time the ASC has no plans to investigate the incident and is waiting to hear from its counterpart in Japan. It is a public holiday in Japan today.
__________________
Al mijn gratis tekeningen vanaf nu te downloaden op http://www.rcplans.nl
prop-er is offline   Met citaat reageren
Oud 10 oktober 2007, 01:26   #8 (permalink)
Benji
Guest
 
Berichten: n/a
Standaard

Zo da's duidelijk dan! thanks voor de info, was al benieuwd wat het nu was, blijkbaar een lamp...

Gelukkig dat er geen passagiers inzaten..
  Met citaat reageren
Oud 10 oktober 2007, 15:18   #9 (permalink)
 
Rhelie's schermafbeelding
 
Lid sinds: 16 september 2004
Locatie: Nootdorp
Leeftijd: 47
Berichten: 6.365
Standaard

Citaat:
Oorspronkelijk geplaatst door prop-er
Het vliegtuig keerde na een half uur terug op hetzelfde vliegveld, omdat de vliegers problemen ondervonden met de snelheidsmeters.
Zou dit te maken kunnen hebben met de lange aanloop ?
__________________
Mustang P51, Calmato Sports, Nova Cuatro, ASH 26 en nog veel meer leuk speelgoed.
Rhelie is offline   Met citaat reageren
Oud 10 oktober 2007, 15:31   #10 (permalink)
 
prop-er's schermafbeelding
 
Lid sinds: 18 september 2004
Locatie: Moordrecht
Leeftijd: 34
Berichten: 3.916
Standaard

Jawel:

Citaat:
When asked why the aircraft appeared to have been travelling down the runway slowly and only got airborne at the end, CAL’s spokesman says there was a problem with the aircraft’s speed indicator. There was a substantial difference between what the captain’s was showing and what the co-pilot’s was showing, he adds.
__________________
Al mijn gratis tekeningen vanaf nu te downloaden op http://www.rcplans.nl
prop-er is offline   Met citaat reageren
Oud 10 oktober 2007, 20:05   #11 (permalink)
hezik
Guest
 
Berichten: n/a
Standaard

Als de Piloot niet ziet dat vrotate bereikt is, zal hij niet opstijgen.

Lijkt mij ook dat ze geen flaps of slats hebben? Zal wel niet..
  Met citaat reageren
Oud 10 oktober 2007, 20:26   #12 (permalink)
 
Nico Peursum's schermafbeelding
 
Lid sinds: 5 augustus 2003
Locatie: Emmeloord
Leeftijd: 45
Berichten: 492
Standaard

Het is standaard om 600m voor het einde van de baan te beginnen met 'trekken', ook als je de rotatiesnelheid nog niet bereikt hebt. Wat je goed kunt zien, is dat de 737 bij een vrij vlakke stand al los komt -> hij heeft dus meer dan genoeg snelheid. Had ie te langzaam gegaan, dan was de staart tegen de baan getrokken
Nico Peursum is offline   Met citaat reageren
Oud 10 oktober 2007, 20:50   #13 (permalink)
MichaelAjax
Guest
 
Berichten: n/a
Standaard

Misschien was er wat mis met de motoren waardoor de piloot te weinig vormogen had om op te stijgen, maar kan erook naast zitten
  Met citaat reageren
Oud 10 oktober 2007, 21:29   #14 (permalink)
 
heije's schermafbeelding
 
Lid sinds: 9 april 2006
Locatie: Belsj Ophoven
Leeftijd: 37
Berichten: 62
Standaard

Normaal gesproken wordt de start ook afgebroken als je op een bepaald punt op de baan V Rot. nog niet behaald hebt en dat heeft men dus ook niet gedaan.

Niet zo slim van de Capt.
__________________
:::Futaba FF10:::T-Rex 600E CF:::X400 Tuned(te koop):::Raptor 50 v2.5:::Raptor 50 V2.0(Robijns Tuned ):::MD500 TOW Defender:::
heije is offline   Met citaat reageren
Oud 10 oktober 2007, 22:13   #15 (permalink)
 
Commander Clumsy's schermafbeelding
 
Lid sinds: 20 februari 2007
Locatie: Belgium, famous for its brushless sprouts
Leeftijd: 46
Berichten: 1.492
Standaard

Wél een leuke presentatrice, zo schooljufachtig als ze overkomt.
'Kijk nu goed, beste kijkbuiskindertjes!'
__________________
Gezocht: Kapotte Air-Ace vliegtuigen http://www.modelbouwforum.nl/forums/...ad.php?t=51519
Commander Clumsy is offline   Met citaat reageren
Ga terug   Modelbouwforum.nl > Algemeen > FullScale-Forum
Reageren

Discussietools
Weergave

Regels voor berichten
Je mag geen nieuwe discussies starten
Je mag niet reageren op berichten
Je mag geen bijlagen versturen
Je mag niet je berichten bewerken

BB code is Aan
Smileys zijn Aan
[IMG]-code is Aan
HTML-code is Uit
Trackbacks are Uit
Pingbacks are Uit
Refbacks are Uit



Alle tijden zijn GMT +2. Het is nu 18:55.


Powered by vBulletin®
Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
Vendor Tools vBulletin Plugins by Drive Thru Online, Inc.
(c) Modelbouwforum.nl, 2002-2010
One of the largest message boards on the web !