Ik heb wat problemen om de regelaar in te regelen terwijl er toch maar een knopje op zit !!!! Het is een Robbe Rookie 8388. een 18 turns regelaar. Wie kan mij de juiste procedure vertellen om deze in te regelen??????
he, ik heb het zelfde probleem, ik vroeg mijzelf al af of er wat te regelen valt. mijn snelheid lijkt een stuk minder, kan dat met de afstelling van de regelaar te maken hebben denk je?
onderstaand heb ik via de robbe site gevonden, ik ga het in ieder geval even proberen, succes ermee gr Arno Programming- To enter programming mode the drive battery voltage must be disconnected briefly. - Leave the throttle stick untouched. - Hold the push-button pressed in until the LED flashes once evenly. - Move the stick to the “full throttle forwards” position and press the button briefly. The LED should now flash twice. - Move the stick to the neutral position and press the push-button again. The LED should now flash three times. - Move the stick back to the “full throttle reverse” position and press the push-button again. - The speed controller is now completely set up and ready to work. If the controller does not appear to work and the LED flashes at the first stage of programming, repeat the programming procedure (you may find that different stick positions work better).Note: You can disable the reverse function by giving a double-press on the push-button when programming the neutral position. The controller now works over the forwards range only. The controller will not work under the following conditions: immediately after you connect the drive battery, after a prolonged period of radio interference, and after the low-voltage circuit or the excess temperature circuit have tripped. You can re-activate the controller by altering the throttle stick position (e.g. forwards - reverse).