New update - while progress have been slow, progress have been made :popcorn: I needed to revise my spot welding technique and I feel the result...
Spot welded the evaporator sticks yesterday, went quite well. The 6mm tubes were flanged on one side and press fit onto the CC-rear wall. 4-6...
For the fuel sticks I used these SS needles, 200mm long: They for easily before and after annealing....
First time for everything, finally found some time to braze the brass tubing and fuel sticks :) Went alright, just needed to apply enough heat and...
Minor update, no pictures yet. The stainless steel needles arrived (5pcs 180mm long) so now I switch drive from software to hardware :) Next up...
Hehe, certainly possible and I haven't carved anything in stone yet :). I am waiting for Mosfets to drive a fuel pump, just got to make the pump...
To make a ground station to operate the turbine, without a radio ;) At the moment I don't have one as I sold my MC24 off a few years back. :rulez:
Thank you very much! Sent you an email Ray :) ECU Monitor prototype one solid step furter :). Step 1 complete. Next step in this department is to...
Thank you, hopefully the magnets will arrive soon. What functions have you been able to incorporate into your ECU? Streaming data and/or functions?
BTW - my RPM circuit with hall sensor, will it be able to read 6-digit RPM values?
I am struggling, pulling hairs but also having fun :) Do you have any input on a good hall sensor to use / magnet part number? I am using a...
Small step for RC turbine, big step for me :) EGT and RPM now reading and displaying correctly :D [MEDIA]
hoeby - Thank you but this is just a very crude start :). Like building the turbine I didn't know Arduino programming/LCD interfacing before I...
My efforts for today :) : [MEDIA]
Ray, yes I mean the evaporator sticks. I have the 4mm ring (and a 6mm) but will go with the smaller one. The thin tubes should arrive shortly......
Minor update, here are the fuel sticks being prepared and a new 4mm OD ring for fuel delivery ready to be brazed. Any reason to choose 4mm over...
@SPOTTER - cool, how far have you gotten with your GR130? @ MadRay66 - yes, if I wanted to fly a turbine I´d just get a cheap 2nd hand unit and...
MadRay - its a nice shop you got there :) Regarding time vs progress, for me this is a journey and a learning experience :) Much of the time I...
Scheid namen met een komma.