Mini H blackout
- Topicstarter johnnypoep
- Startdatum
johny: connect 3,3v to pin 44 of the cpu. it will do boot from rom 
same as boot pins.
same as boot pins.3.3v u can get from naze satelkite power pins. be carefull.
Realy? Greatttt I go home to check that out! Can you share a picture of the location on the nase how to and where to do that?
Laatst bewerkt door een moderator:
ok. me go out to fly now
good luck. be very carefull! its tiny.To be sure is it this pin @Fedorcommandor ?
Laatst bewerkt door een moderator:
well. count ccw from pin 1
yap.
.... my go thats tiny...
use a needle
i sugfedt yo use second pair if hands for vonnecting to laptop. when u boot in bootliader mode only one led should be on. no freen red blinking. after that h can release this wire
im scared
Alle lights turn off :s.. what I did was put pin in 3.3v then to the cpu and then connect the usb cable.. then there are no lights at all. Unfortunatly. When I ket go of the pin from the cpu then the blue solid and green is blinking.
Laatst bewerkt door een moderator:
I do get a solid blue light when make a jumper from the original boot pad (left pad) to the pad where the trace from the second boot pad ends.. I see in cleanflight for a couple seconds "connection bootloader" but then it change again to "no reponse from bootloader, connection failed"... 
but yes there is a blue solid light on the naze board !
but yes there is a blue solid light on the naze board !
Laatst bewerkt door een moderator:
looks horrible.
i hope u connect to pin 44 without boot pins shorted. otherwise u just make connection to the ground. well. pin44 should have 0 too bot from flash and 1 to boot from rom. normally its connected via resistor to the ground. i cant see in thus mess what is what. when u short boot pins you pretty much connecting pin 44 to 3v. donething is wrong there. blue led is just connected to 3v and should be always lit if power present. cpu cant turn it off. that means i make short cirquit somewhere.
Hi @FedorCommander hope you had a great flight! maybe I am doing it wrong... okay here is what I did.
1. solderd a small wire to the 3.3v on the naze like you showed me on the picture.
The other end I hold on the pin of the cpu and then connect the usb in to the naze32. There where no lights at all. Untill I released the cable end from the CPU.
1. solderd a small wire to the 3.3v on the naze like you showed me on the picture.
The other end I hold on the pin of the cpu and then connect the usb in to the naze32. There where no lights at all. Untill I released the cable end from the CPU.
i think i have connection from 44 to ground somewhere. blue led should be on No matter what
yes strange.. If I let go of the wire from the CPU I see a solid blue and green flashing
@FedorCommander you have another option to boot? I realy appreciate your help!
Laatst bewerkt: